Skip to main content

Why does Nomni POS say "Printer is not ready to print" for my Zebra label printer?

How to get a paused Zebra label printer printing again: close the lid, check the labels and resume it.

Quick answer: Nomni POS shows Printer is not ready to print when your Zebra label printer tells it that it can't print right now. This usually means the printer is paused, the lid (print head) is open, or it's out of labels. Close the lid until it clicks, check the labels are loaded, then press the PAUSE button once to resume. Opening the lid often pauses the printer, so restarting it alone may not fix it.

Who this is for: venue staff and managers using Nomni POS on iPad with a Zebra label printer (for example a ZD410 or ZD420) for drink or item labels.


How do I get my Zebra label printer printing again?

  1. Look at the status light on the front of the printer. Solid green means ready. Flashing, amber or red means the printer needs attention.

  2. Open the lid and check the label roll is loaded under the guides, sits under the sensor and isn't empty. If it's empty, load a new roll.

  3. Close the lid firmly with both hands until it clicks shut on both sides.

  4. Press the PAUSE button once to resume printing. The printer pauses itself after the lid has been opened, and it won't print until you resume it.

  5. Wait until the status light is solid green.

  6. Send a test order from Nomni POS with an item that prints a label.

What you should see: the status light is solid green, the message stops showing, and a label prints for the item in your test order. Labels that were waiting to print may print too.


What if the light still flashes or labels print blank?

The printer may need to measure the labels again (calibrate).

  1. Make sure the printer is on, the lid is closed and the light is solid green.

  2. Press and hold the FEED button.

  3. When the light flashes twice, let go straight away. The printer feeds a few labels while it measures them.

  4. Tear off the fed labels and send another test order.

What you should see: one clean label per item, lined up inside the label edges. For more help, see How to calibrate a Zebra label printer.


What if it still says "Printer is not ready to print"?

  • Turn it off and on: turn the printer off, wait 10 seconds, turn it back on and wait for a solid green light. Then send a test order.

  • Labels stuck or jammed: open the lid, remove any stuck or curled labels, reload the roll, close the lid until it clicks and press PAUSE again.

  • The message changes to a connection error: the printer is no longer reachable on your network. Check its network cable and that it's on the same network as the iPad. See How to fix a printer that isn't printing, by printer model.


Need help?

Email [email protected] or call 1300 445 483. Tell us your store name, the printer model, what colour the printer light is and whether it's flashing, and a photo of the printer if you can.

Did this answer your question?